Single Sided Helmet Speaker Pad with Microphone for GATH

شناسه محصول: B02G دسته: , برچسب:

Waterproof IPX7

Single sided helmet speaker pad with microphone for your GATH helmet by BbTALKIN USA. This pad fasten to the left side of your helmet by a marine grade Velcro. Please refer to the chart above to make sure this headset is compatible with your style GATH helmet. This headset is not compatible with all GATH helmets. If you own a GATH helmet that does not work with this headset, please use our standard single sided headset.

This helmet pad is designed to be used with our Advance Unit.  You plug the boom microphone’s 3.5mm audio cable directly into your Advance Unit to establish communication. The microphone and speaker piece on the helmet pads are completely waterproof. The design of the helmet pad allows the flexibility to change out either the microphone piece or speaker piece if it becomes damaged over time.

Click here for downloadable instructions.

WARRANTY

From the date of purchase, the helmet speaker pad and all it’s components are covered for 6 months. Please see our warranty section for complete warranty details.

SKU: B02G

EAN: 4713309040252

Rubber helmet speaker pad, left side with Velcro tape

  1. Use fresh water to wash all of the headset.
  2. Make sure to rinse the microphone and speaker piece.
  3. DO NOT use high pressure spray.
  4. Best to submerge in bucket of fresh water for through wash.
  5. Hang to dry in a well ventilated place.

If using in salt water, you must fresh water rinse. Failure to do so can cause corrosion and product failure.

1. Use the alcohol prep to clean up the helmet surface. You must clean the surface of your helmet to insure the 3m tape will adhere to the surface. The 3m tape will not adhere to rubber surfaces.
2. Remove the audio vents from your GATH helmet.
3. Attach the helmet speaker pad Velcro tape onto the left side of the helmet over the area where the audio vent use to be.
4. Install the plastic mount onto the left side of your helmet, just above the helmet speaker pad.
5. Mount the waterproof case into the plastic mount. Make sure both sides of the casing is securely into the mount.
6. Plug in the 3.5mm audio cable. Make sure the cable is tight and secure. Failure to do so will cause water intrusion into the casing. Any water damage to the unit within the casing is not covered under warranty.
7. Make sure after each use that your case is secure and sealed.

x1: Single sided helmet speaker pad with microphone and Velcro